Ecotex® Water Based Screen Printing Ink Jet Black

Ecotex® Water-Based Screen Printing Ink Jet Black is a stand-alone black water-based screen printing ink that is ready from the container and cannot be discharged. Jet Black Water Based Ink produces very fine image detail, a soft hand and can be printed on high mesh counts. Our ink can be used with other inks to create multiple effects. 

For Ecotex Water-Based Ink Hex Codes and Digital Swatches Click here

For more information on water-based inks follow along in our - Water Based Printing blog. 

Mesh Guidelines: 155-305

Flash and Curing Guidelines:

• Curing should be a minimum of 90 seconds at 320°F. For the best results 2-3 minutes at 320°F.
• Flash at 105°C/220°F - 7 - 12 seconds

Recommended Clean-Up:

• On the press/in the sink - Ecotex® Water Based Screen Printing Press Wash

For Optimal Use:

• Mist the screen with water during high-volume runs to prevent the ink from drying out

Emulsion Recommendations: We recommend using a water-resistant emulsion such as Water Resistant Blue Emulsion or Dual Cure Pink Emulsion, both require mixing diazo. Remember to degrease your screen before coating the emulsion, Hyper Haze will degrease and remove stains/ghosts.

General Testing: Before you do any large print, we recommend doing a stretch and a wash test to ensure you are cured and printed correctly before going into production. Increase cure time if testing fails. We recommend only using natural fibers; the best results will be seen on 100% cotton. Synthetic fibers will not discharge properly.

Warning: This product can expose you to chemicals including ethanediol, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov

Click Here for Safety Data Sheet